Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Power Down ACE / GSS

Is there a recommended procedure to shutdown the ACE and GSS?

I have to change sites and need to know this information.

Regards,

Jaime

1 REPLY
Bronze

Re: Power Down ACE / GSS

Hello Jaime-

The GSS has a "shutdown" command at the enable prompt.

For the ACE 4710 - you can hold down the power button on the front, there is no cli command.

For the ACE10-mod-k9 and ACE20-mod-k9, you can issue "no power enable module X"

On a side note, there is a "shutdown" button on the front of the ACE modules that you can use a paperclip to access. However, functionality of this button is actually to reset the module, not power it off.

cat-1#sh module
Mod Ports Card Type                              Model              Serial No.
--- ----- -------------------------------------- ------------------ -----------
  1    6  Firewall Module                        WS-SVC-FWM-1       SAD084305R8
  2    1  Application Control Engine Module      ACE10-6500-K9      SAD094701MY
  3    1  Application Control Engine Module      ACE20-MOD-K9       SAD1141053B
  5    2  Supervisor Engine 720 (Active)         WS-SUP720-3BXL     SAD081200ES
  6   48  48-port 10/100 mb RJ45                 WS-X6148-RJ45V     SAL0651ADR6
  9    3  AON Module                             WS-SVC-AON-1-K9    SAD08320722

cat-1(config)#no power enable module ?
  <1-9>  module slot number

cat-1(config)#no power enable module 3

%Power admin state updated

Regards,

Chris Higgins

784
Views
0
Helpful
1
Replies
CreatePlease to create content