But for sure you don't need when your rserver are remote.
If you do not configure an ip address under the probe definition, probes are sent to the real ip address and ACE will check its routing table to check how to reach the real.
Basically, you would use that routed option if you want the probe to be sent to a different ip address than the real address and if you want to override the default routing decision which is to send the probe using the same path as to reach the real.
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...