Question about ACE show Conn command (tcp duration)
I was checking connections and noticed that I would see the initial connection, but after a short time the connection quits showing up in the counters and the “show conn” command. However the user is still up and working.
This is the command I used:
sho conn serverfarm STAGING-HTTPS detail
The output shows all the connection info from source to destination, and in the ESTABLISHED state.
However, after maybe 2~3 minutes, when I up arrow I don't see any connection info. The web page is still up. If I refresh the web page, I do see the connections come in.
Can someone kindly point me to a document or provide an answer on how long should the connection be stored before they are flushed?
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...