Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Bronze

Question about the command to force the standby CSM to be active

Hi everyone,

Is there any command to force the standby CSM (Content Switching Module on Catalyst 6500) to be active ?

such as "redundancy force-master" command on CSS.

I can not find such command on CCO.

Your information would be appreciated.

Regards,

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Question about the command to force the standby CSM to be ac

clear module csm x ft active

(make sure peremption is disabled befor you run this command).

Thanks

Syed

2 REPLIES

Re: Question about the command to force the standby CSM to be ac

clear module csm x ft active

(make sure peremption is disabled befor you run this command).

Thanks

Syed

Bronze

Re: Question about the command to force the standby CSM to be ac

Syed,

Thank you very much for your reply.

Shinichi

260
Views
0
Helpful
2
Replies
CreatePlease login to create content