Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Question of CSM failover

There are two separate Cat6513 chassis each contain a CSM.We configured as active/standby.According to my understand, the traffic should be gone through only active one. But when I tried to "sh module contentSwitchingModule 5 conn" on the standby one, I also found out bunch of connections. If I am wrong, please correct it. Thanks for your help!

3 REPLIES
New Member

Re: Question of CSM failover

I too think that traffic should only go through the active CSM.

However, I found out that the standby unit would still probe the serverfarms so see if those connections are your probe traffic.

New Member

Re: Question of CSM failover

But why I also could find the CSM connection generated in the standby one?

Anybody could explain it, Thx a lot!!

Cisco Employee

Re: Question of CSM failover

The load balancing connection will be through the ACTIVE CSM. But if you have probes configured then you would see those connection to the standby csm also.I believe you are seeing the PROBE connections on the standby CSM. These wont be load balancing connections

146
Views
0
Helpful
3
Replies