I have a new GSS 4492R appliance, running v4.1(1) out of the box, and presently attempting to configure it (creating region, location, etc.) per the GSLB configuration guide. When attemping to issue commands under the "config-gslb" config mode, the following is returned:
Unable to Determine GSS Status.
Command Execution Failed.
Consulted several GSS user guides and performed online searches related to the above and haven't been able to figure out why such behavior. Can someone please assist? Just trying to configure the appliance as an authoritative NS for private/public domain(s). Thanks.
Looks like defect CSCtr63776 "Interface config got wiped off while configuring HTTPs kal" which was duplicated to defect CSCtr63776 "Interface config got wiped off while configuring HTTPs kal". This is fixed in 18.104.22.168. Release notes indicate that reload without saving config should resolve.
partial config loss on platform.cfg leads to box not accessible state.
This has been observed in couple of box, where partial loss of running.cfg/platform.cfg which leads to box not accessible condition, as platform key data's like ethernet, ssh, telnet ...etc are been wiped off, bringing the running box to down state. multiple thead or process accessing to platform.cfg leading to config loss state.
Reload the box with out saving the current configuration when it asks during reload.
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...