Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

redundancy not active after upgrade version from 7.4 to 7.5

I've upgraded both Cisco CSS11506 Load Balancer to ver 7.5. However, the Box-to-Box LoadBalancer is not running when " show redundancy".

Box A configure

circuit VLAN1

description "Management VLAN for SW2950"

ip address 192.168.xx.253 255.255.255.224

ip virtual-router 1 preempt

ip redundant-interface 1 192.168.xx.254

ip critical-service 1 upstream_downstream

circuit VLAN2

description "E-Bill Circuit"

ip address 192.168.xx.29 255.255.255.224

ip virtual-router 2 preempt

ip redundant-interface 2 192.168.xx.30

ip redundant-vip 2 192.168.xx.17

ip redundant-vip 2 192.168.xx.23

ip critical-service 2 upstream_downstream

Box B configure

circuit VLAN1

description "Management VLAN for SW2950"

ip address 192.168.xx.252 255.255.255.224

ip virtual-router 1 priority 105 preempt

ip redundant-interface 1 192.168.xx.254

ip critical-service 1 upstream_downstream

circuit VLAN2

description "E-Bill Circuit"

ip address 192.168.xx.28 255.255.255.224

ip virtual-router 2 priority 105 preempt

ip redundant-interface 2 192.168.xx.30

ip redundant-vip 2 192.168.xx.17

ip redundant-vip 2 192.168.xx.23

ip critical-service 2 upstream_downstream

CSS506INT3# show redundancy

Redundancy: Disabled Redundancy Protocol: Not Running

Redundancy is running before upgrade. Is anything wrong??

  • Application Networking
1 REPLY
Cisco Employee

Re: redundancy not active after upgrade version from 7.4 to 7.5

show redundancy would never show you anything with this config.

'show redundancy' is used for Box-to-Box redundancy.

What you have configured is VIP/Interface redundancy.

You need to use the command :

show redundant-?

redundant-interfa.. Show redundant-interface information

redundant-vips Show redundant-vip information

regards,

Gilles.

Thanks for rating this answer.

111
Views
0
Helpful
1
Replies