I currently have a production WAAS environment leveraging WCCPv2 for redirection with a single WAAS at each of my 3 data centers. I want to add a second WAAS into the WCCP for each location. Can somebody please provide a link for configuring this? I have seen you can do multi-cast or unicast wccp groups. Is that correct? Is there a benefit to one over the other. Thanks for your help.
Also, about unicast and multicat deployment the only difference is that On each WAE you need to configure multiple unicast router addresses in the WCCP router list, one for each router in the service group for unicast whereas for multicast, you just need to specify multicast group-address.
Why do you need native HA: The native HA feature allows two Cisco DCNM
appliances to run as active and standby applications, with their
embedded databases synchronized in real time. Therefore, when the active
DCNM is not functioning, the standby DCNM will...
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...