I have to replace a faulty CSS 11150 as the hard disk is bad.The present code is 6.10 build 405.There is a box-to-box redundancy in between the 2 CSS's,the server and client VLAN is same i.e, the CSS is in bridged mode.What is the best way to replace the CSS in this kind of scenario? Can this be done in a hitless manner considering there is a backup CSS?
Thanks for a quick response..what are the bare minimum settings I have to do on the replacement CSS to be able to Sync the config?Do I have to have all the uplinks and heartbeat cable in place to do the sync or I can do it just by connecting the heartbeat cable?
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...