Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

rserver behind VIP

Hi All,

I have a scenario where an rserver needs to initiate a connection but needs to be hidden behind it's VIP address.

Does anyone know how this is configured, im guessing some kind of source is needed as by default the rserver will use it's real address by default?

Thanks

Kris

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: rserver behind VIP

Hi Kris,


Have a look at the link below. It describes the configuration you need for the topology you described. It was written for an ACE module, but the ACE appliance should be basically the same.

http://www.cisco.com/en/US/products/hw/modules/ps2706/products_configuration_example09186a00809c6ef5.shtml

Let me know if you have questions about the specific parts of the configuration.

Daniel

1 REPLY
Cisco Employee

Re: rserver behind VIP

Hi Kris,


Have a look at the link below. It describes the configuration you need for the topology you described. It was written for an ACE module, but the ACE appliance should be basically the same.

http://www.cisco.com/en/US/products/hw/modules/ps2706/products_configuration_example09186a00809c6ef5.shtml

Let me know if you have questions about the specific parts of the configuration.

Daniel

254
Views
0
Helpful
1
Replies
CreatePlease to create content