Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

RTP/RTCP stream load balancing with CSS

Hi,

Is there any way to load balance RTP/RTCP streams with css?

4 REPLIES
Cisco Employee

Re: RTP/RTCP stream load balancing with CSS

Hi,

The CSS is able to balance the traffic at layer 4 (just looking at the ports), so there should be no problem.

The trick is to give the correct TCP port numbers.

About RTP/RTCP, I am not familiar with the protocol, but if it works with TCP, then here again, the correct port numbers should work.

Hope it helps!!

New Member

Re: RTP/RTCP stream load balancing with CSS

Hi,

I agree about TCP, but it seems that RTP is using dynamicly assigned ports.

Cisco Employee

Re: RTP/RTCP stream load balancing with CSS

If the ports are not always the same you can have the CSS configured with a layer 3 rule (listening for any TCP port).

New Member

Re: RTP/RTCP stream load balancing with CSS

Tnx for the info.

376
Views
6
Helpful
4
Replies
CreatePlease to create content