Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Saving config to passive SCM

Hello.

I am configuring a CSS 11506 for the first time (image is sg0820201). I am not sure if when I type "write mem" in active SCM the config also goes to the passive one.

I can do it in boot mode, but this way the CSS restarts and all available services go down.

Thanks in advance,

Joao Carvalho

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Saving config to passive SCM

the CSS should not restart after typing those commands.

If it does, do a 'show core' to see if there is any core file.

In case you do have core files, you need to open a service request w/ the TAC and provide the core file so it can be analysed.

Gilles.

4 REPLIES
Cisco Employee

Re: Saving config to passive SCM

The command to use is :

passive sync startup-config

from the boot config mode and after a write mem.

Gilles.

Community Member

Re: Saving config to passive SCM

Does your CSS restarts after you type these commands?

Joao Carvalho

Cisco Employee

Re: Saving config to passive SCM

the CSS should not restart after typing those commands.

If it does, do a 'show core' to see if there is any core file.

In case you do have core files, you need to open a service request w/ the TAC and provide the core file so it can be analysed.

Gilles.

Community Member

Re: Saving config to passive SCM

Thanks for your help.

Joao Carvalho

117
Views
0
Helpful
4
Replies
CreatePlease to create content