Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Server-to-Server connections Failing

Hi All,

Having problems with Server-to-Server connections through a CSS11501. Servers are on the inside, and connect through vip address. would this a valid configuration ?

would appreciate any suggestion.

Thx in advance.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Server-to-Server connections Failing

you have to make sure the response from the server goes back to the CSS in order to nat the server ip back to the vip ip otherwise the client[server] will reject the answer.

If the 2 servers are in the same subnet, the response will go directly to the client-server.

The solution is to configure client nat for server to server traffic.

Regards,

Gilles.

Thanks for rating this answer.

2 REPLIES
Cisco Employee

Re: Server-to-Server connections Failing

you have to make sure the response from the server goes back to the CSS in order to nat the server ip back to the vip ip otherwise the client[server] will reject the answer.

If the 2 servers are in the same subnet, the response will go directly to the client-server.

The solution is to configure client nat for server to server traffic.

Regards,

Gilles.

Thanks for rating this answer.

New Member

Re: Server-to-Server connections Failing

THANKS ALOT FOR YOUR RESPONSE!

161
Views
0
Helpful
2
Replies
CreatePlease to create content