06-26-2012 11:22 PM
Hi ,
Could some one explain "sh arp" command in ACE.
Example:
================================================================================
IP ADDRESS MAC-ADDRESS Interface Type Encap NextArp(s) Status
================================================================================
172.16.161.4 e1.5f.b9.a1.b8.ab vlan1301 INTERFACE LOCAL _ up
172.16.161.5 e1.5f.b9.a1.61.1d vlan1301 LEARNED 157 13287 sec up
172.16.161.51 10.50.56.a6.00.04 vlan1301 RSERVER 16 82 sec up
172.16.161.253 10.0b.fc.fe.1b.01 vlan1201 NAT LOCAL _ up
172.16.163.4 e1.5f.b9.a1.b8.ab vlan1303 INTERFACE LOCAL _ up
172.16.133.249 10.00.0c.07.ac.01 vlan1299 GATEWAY 37 14 sec up
whats is
1) Interface local ?
2) Learned ?
3) RSEVER ?
4) NAT Local ?
5) Gateway ?
and when can or how do we use this table for ?
06-27-2012 01:35 AM
Hi Rajkumar,
1) Interface local ? <<< IP address on that particular VLAN >>>
2) Learned ? <<< IP learned outside of ACE >>>
3) RSEVER ? <<< Real server ARP entry >>
4) NAT Local ? << It should be Natted IP which is from NAT pool of ACE >> ( Need to check )
5) Gateway ? << Of course the default gateway >>>
Hope that helps.
regards,
Ajay Kumar
06-27-2012 01:57 AM
Ajay ,
could you please explain some more on " Learned" parameter
if possible some example
Thank you
06-27-2012 02:10 AM
Hi Rajkumar,
For example:
10.10.10.10 00.50.56.b4.6a.ee vlan124 LEARNED 4 5320 sec up
(Ip of the client or any system which tried to contact VIP or ACE ) MAC address : 00.50.56.b4.6a.ee
It is reachable from VLAN 124. It is learned address. It is up from last 5320 seconds.
hope that helps.
regards,
Ajay Kumar
06-27-2012 02:16 AM
Thank you very much Ajay..
i got it , Good explanation !!..
Regards
Raj
06-27-2012 02:37 AM
Good to hear that. Thanks.
regards,
Ajay Kumar
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: