I am quite a newbie with ACE configurations. I have a VLAN i want to share over three ACE context's. Every context needs to have its own vlan ip address. How can i manage to do this ? I can only define an ip address on the main ACE configuration.
You are probably talking about the transfer-network or client-side VLAN.
If you have already assigned the vlan to the module from the cat6k just create the three contexts and assigned those vlans to each context. That is how i do it. Serve three different context's with three different server networks with one client-side or transfer-network.
just make sure you use different ip's for the ip,peer ip and alias for each context if you use FT or 2 modules. With this setup i always need 4 IP's including the VIP per context on the client side.
Then you can configure the shared vlan in each context separate.
The unmanaged mode is also known as Network only switching, which is introduced in Brazos release. It adds the flexibility for customer to use only network automation for service appliance.
If a device is configured a...
Usually, we can access ESXi Shell by pressing Alt+F1 from ESXi DCUI (Direct Console User Interface).
But on HyperFlex system, it just shows black window.
This is expected behavior because HyperFlex redirects ESXi Shell output to SoL...
Configuring an Export Policy Using the GUI
This procedure explains how to configure an Export policy using the APIC GUI. Follow these steps to trigger a backup of your data:
On the menu bar, choose Admi...