Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Show flows returns a prompt without any flows

CSS11503 running:

CSS11503# sh ver

Version: sg0710206A (7.10 Build 206)

Flash (Locked): 7.10 Build 206

Flash (Operational): 7.10 Build 206

Type: PRIMARY

Licensed Cmd Set(s): Standard Feature Set

When I display a show flows it doesn't return flows. This has happened twice, approx. 2 days after we have rebooted some of the servers that we have configured on the content switch. The only way that I have been able to recover this is to reboot the CSS11503. There hasn't been a change made to the CSS during this period. Any feedback would be helpful.

  • Application Networking
2 REPLIES
Cisco Employee

Re: Show flows returns a prompt without any flows

go in llama mode and do 'flow-agent show active'

Do you see any flow ?

Is this a single box or is it working in redundant mode ?

I would also strongly recommend an upgrade to 7.40 or 7.50.

We don't really support 7.10 anymore.

Gilles.

New Member

Re: Show flows returns a prompt without any flows

We are running a single box. I understand that we should upgrade but until we can get a second box to put the new code on and test it is very difficult to do in our environment. Next time we have the issue I will see what your command outputs.

126
Views
0
Helpful
2
Replies