Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

show serverfarm

When displaying show serverfarm we get the following

EWDC-T1ACE12-1/Media# show serverfarm x.x.x.x-2X-primary

serverfarm : x.x.x.x-2X-primary, type: HOST

total rservers : 1

---------------------------------

----------connections-----------

real weight state current total failures

---+---------------------+------+------------+----------+----------+---------

rserver: nj09mhm0036

172.28.34.31:0 8 OPERATIONAL 16 4868 244

How do we know what those failures are ? Out of 4868 connections we have 244 failures. How do u dig into it?

1 REPLY

Re: show serverfarm

Hi Cric,

Use the following 2 commands:

EWDC-T1ACE12-1/Media# show serverfarm name x.x.x.x-2X-primary detail

EWDC-T1ACE12-1/Media# show conn serverfarm x.x.x.x-2X-primary

Field Descriptions for the show conn serverfarm Command Output

Field

Description

Conn-ID

Numerical identifier of the connection.

Dir

Direction of the traffic on the connection: in or out.

Prot

TCP/IP protocol used for this connection.

VLAN

Numerical identifier of the virtual LANs used in the inbound and the outbound connections.

Source

Source IP addresses and ports of the inbound and outbound connections.

Destination

Destination IP addresses and ports of the inbound and outbound connections.

State

Current state of the connection. Non-TCP connections display as "--". Possible values for TCP connections are as follows:

INIT-Connection is closed. This is the initial state of a connection.

SYNSEEN-ACE received a SYN packet from a client

SYNACK-ACE sent a SYNACK packet to a client

ESTAB-Three-way handshake completed and the connection is established

CLSFIN-ACE closed the connection with a FIN packet

CLSRST-ACE closed the connection by resetting it

CLSTIMEOUT-ACE closed the connection because the connection timed out

CLOSED-Connection is half closed

Sachin garg

333
Views
0
Helpful
1
Replies
CreatePlease to create content