What command will show the types of GBICs that are installed in the ports of SCM-2GE or IOM-2GE modules? I've tried various combinations of the "show chassis" command (and others) and can't get it to show whether or not there is a GBIC inserted, or what model GBIC it is.
Serial Number: JAB09xxxxxx Base Mac Address: 00-13-80-37-xx-xx
Slot Module Serial
---- -------------- ------------
1 CSS5-SCM-2GE F0 JAB0915xxxx
2 CSS5-SCM-2GE F0 JAB0914xxxx
3 CSS5-SSL-K9 F0 JAB0848xxxx
4 CSS5-IOM-2GE E0 JAB0808xxxx
7 CSS506-SM E0 JAB0911xxxx
8 CSS506-SM E0 JAB0911xxxx
No useful information there. Even a "show chassis verbose" command does not indicate the presence of a GBIC. It shows the Operational Status of a port as "online" whether there is a GBIC installed or not. For example, in the output below Slot 4 has a GBIC installed in port 4/1, but 4/2 is empty:
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...