Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Shutdown service in ACE using SNMP

Dear Mister

Is possible to configure, shutdown a service using SNMP? More than this, in a context???

I am searching the OIDs about it, but, I am not lucky.

Regards and thank in advance

 

2 REPLIES
Cisco Employee

Hi,I don't think so. You have

Hi,

I don't think so. You have list of MIB's available which can fetch data from ACE but there is no such provision to shut down the service using SNMP. The ACE supports traps and SNMP get requests but does not support set requests to configure values on the device. Please visit the below link for more information:

http://www.cisco.com/c/en/us/td/docs/interfaces_modules/services_modules/ace/vA5_1_0/configuration/administration/guide/admgd/snmp.html

Regards,

Kanwal

Cisco Employee

Rodrigo,What is the version

Rodrigo,

What is the version of the ACE that you have? and which model -- appliance or module?

Here is a list of things that you can do on an ACE 4710 or ACE 30 running A5(x.x) code:

http://www.cisco.com/c/en/us/td/docs/interfaces_modules/services_modules/ace/vA5_1_0/configuration/administration/guide/admgd/snmp.html#wp1034221

Let me know if you have any further questions.

-

Devendra Vishwakarma

 

**Please rate helpful posts**

57
Views
0
Helpful
2
Replies
CreatePlease to create content