10-15-2007 01:12 AM
How do I erase the running config of a context ? wr erase only gets rid of the the start up. I can go through it with no commands but was hoping there is a better way.
Solved! Go to Solution.
10-15-2007 02:49 AM
If you could reload per context erasing the startup config would work. Unfortunately you can only reload the whole ace blade.
Fastest way to get rid of a config within a context is to delete the context in the admin context and then re-create it.
changeto Admin
conf t
no context
context
If you had checkpoints already created those are gone as well once you issue the "no context
To make it easier in the future i would suggest you create an empty checkpoint at the very beginning or at the point of your configuration where you want to start to experiment with the settings.
conf t
checkpoint create
or
checkpoint create
To get the settings back u issue.
conf t
checkpoint rollback
The checkpoints are per context btw.
Hope that helps.
Roble
10-15-2007 02:49 AM
If you could reload per context erasing the startup config would work. Unfortunately you can only reload the whole ace blade.
Fastest way to get rid of a config within a context is to delete the context in the admin context and then re-create it.
changeto Admin
conf t
no context
context
If you had checkpoints already created those are gone as well once you issue the "no context
To make it easier in the future i would suggest you create an empty checkpoint at the very beginning or at the point of your configuration where you want to start to experiment with the settings.
conf t
checkpoint create
or
checkpoint create
To get the settings back u issue.
conf t
checkpoint rollback
The checkpoints are per context btw.
Hope that helps.
Roble
10-16-2007 03:19 AM
Just in case anyone is stuck...
ace-1/Con1(config)# checkpoint?
% invalid command
ace-1/Con1# checkpoint create test
Generating configuration....
Created configuration checkpoint 'test'
ace-1/Con1#
Thanks Roble
10-16-2007 08:18 AM
Ooops...
I am so used to "configuration" mode that i actually didn't verify that it's a privilege mode command.
Happy to hear it helped.
Roble
09-17-2009 05:06 AM
Hi,
To revert the ACE back to factory default settings, is it then enough to erase the admin context config, or do I have to delete each context individually and then delete the Admin context config?
Thanks alot.
Dario
09-17-2009 06:23 AM
Hi Dario,
I believe a write erase in the admin context & reload should do it.
Could you let me know how it goes? I don't have a test platform.
Cheers,
Claire
09-18-2009 03:25 AM
Hi,
Yes, wr erase in the admin context does the trick!
thanks alot,
Dario
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: