I have a Cisco ace 4710 with vesion Version A4(2.2). i configued simple SIP load balancing first without stickiness. without stikeiness we are having a problem because bye packet at the was not going to the same server all the time that left our port in used even though user hang up the phone. its happen randmly. i have a total 20 licenced ports and its fill out very quickly. so i dicided to use the stickiness with call-ID but still same issue. below is the config
rserver host CIN-VOX-31
ip address 172.20.130.31
rserver host CIN-VOX-32
ip address 172.20.130.32
serverfarm host CIN-VOX
sticky sip-header Call-ID VOX_SIP_GROUP
class-map match-all CIN_VOX_L4_CLASS
2 match virtual-address 172.22.12.30 any
class-map match-all CIN_VOX_SIP_L4_CLASS
2 match virtual-address 172.22.12.30 udp eq sip
policy-map type loadbalance sip first-match CIN_VOX_LB_SIP_POLICY
ya.. dont have this in my config. i thought this is just if you wthanted to do layer 7 load balancing. i have a without match criteria. well i can try to add this and see how that works.. i will let you know...
Why do you need native HA: The native HA feature allows two Cisco DCNM
appliances to run as active and standby applications, with their
embedded databases synchronized in real time. Therefore, when the active
DCNM is not functioning, the standby DCNM will...
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...