Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SNATing servers

We're running ACE SM (A2_1_.5a) in bridge mode and have 4 rservers in the serverfarm, where 2 of them are directly connected and the other 2 are disjointed. We would obviously have to SNAT the disjointed servers, however since they are all in the same serverfarm, would probably have to SNAT the directly connected ones as well, which is an overkill. Can we do SNAT on a server level or only on the layer 7 policy level?

Thanks..

1 REPLY
Cisco Employee

Re: SNATing servers

If your remote servers are accessible through a different interface than the local ones, there will be no problem.

The dynamic nat command takes the outgoing vlan as a parameter.

If the traffic is not forwarded through that vlan, it is not nated.

Gilles.

213
Views
0
Helpful
1
Replies