03-24-2011 06:43 AM
Hi All,
I am doing an snmpwalk on our ACE using the following oid:
1.3.6.1.4.1.9.9.161.1.4.2.1.9
The problem is that on some vips after doing an snmp walk I am receiving 0 for bandwidth utilisation.
When I scan the device I see there is bandwidth usage.
Below is output form snmpwalk and the device itself.
SNMP-Walk
1.3.6.1.4.1.9.9.161.1.4.2.1.2.2.222 : Counter: 0
sh service policy CM-Rebranding-888-http
class: CM-Rebranding-888-http
VIP Address: Protocol: Port:
10.x.x.x tcp eq 80
loadbalance:
L7 loadbalance policy: PM-Rebranding-888-http
VIP Route Metric : 77
VIP Route Advertise : DISABLED
VIP ICMP Reply : DISABLED
VIP State: INSERVICE
curr conns : 3374 , hit count : 8113708
dropped conns : 82195
client pkt count : 186343165 , client byte count: 17308888870
server pkt count : 292836401 , server byte count: 362759465286
conn-rate-limit : - , drop-count : -
bandwidth-rate-limit : - , drop-count : -
L7 Loadbalance policy : PM-Rebranding-888-http
class/match : class-default
LB action: :
sticky group: Rebranding-888-http
primary serverfarm: SF-Rebranding-888-http
state: UP
backup serverfarm : -
hit count : 8113703
dropped conns : 0
Parameter-map(s):
Rebranding-888-http-Idle
It looks like a bug to me.
Any help would be appreciated in understanding this issue.
If anyone has encounterd this issue and overcome it please let me know.
Thanks.
Jack.
04-08-2011 06:33 AM
Jack
Probably easiest if we can set it up in the lab and test it. Would you be willing to share your config ? Or maybe open a tac case and I can take a look at it. Which version of s/w ?
Matthew
04-10-2011 05:18 AM
Hi Matthew,
I have no problem either way opening a TAC or sending you the configs.
The version is 2.3.2.
Thanks.
Jack.
04-13-2011 09:35 AM
Probably a TAC case is easiest. Ask that it is directed to me (mwinnett).
Matthew
04-13-2011 09:35 AM
Hi Matthew,
No problems sharing the config and or opening a TAC case.
The version in use on the ACE is 2.3.2.
Thanks.
Jack.
04-13-2011 11:46 PM
Hello Jack, send me the config, please and I'll load it to a lab box. Matthew
04-13-2011 11:49 PM
Hi matthew,
Can you please provide me with your work email address and I'll attach the config for you?
Thanks.
Jack.
04-14-2011 12:00 AM
04-14-2011 12:07 AM
Sent.
Thanks.
Jack.
04-27-2011 03:53 AM
Hello Jack, I have done some lab work. Can you email me (mwinnett@cisco.com) so I can reply privately
matthew
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: