Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

snmp enable traps slb ft

I trying to enable snmp traps on the CSM-S in order to get notification through HP Openview Network Node Manager that a 'fault tolerant' event has taken place. I am running 2.1(5) code.

I found the command reference for the CSMS 2.x code:

http://www.cisco.com/en/US/customer/docs/interfaces_modules/services_modules/csms/2.1.1/command/reference/s.html#wp1057213

There is a reference to the command: snmp enable traps slb ft

This is supposed to send an SNMP trap when the CSM transitions from standby to active after detecting a failure in its fault tolerant peer.

This example shows how to enable fault tolerant traps:

Cat6k-2(config-module-csm)# snmp enable traps slb ft

This command is not available in CSM configuration mode. In fact, there are no snmp commands at all in the CSM config mode.

Do I have to enable something globally on the 6500 first?

188
Views
0
Helpful
0
Replies