We have two CSS11154's in an master/slave configruation. There is only one unique address on each of the switches, we are addressing snmp polls to these addresses. The slave/secondary switch responds correctly, however the Master responds to the snmp polls with the IP address of the closest interface.
understandably, the replys are not heard.
I checked all of the litrature, and I am unable to find anything that references this issue. Has any one else run into it, or know of a S/W release in which it has been fixed (I am sure that this is a bug)
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
In the Previous articles of ACI Automation, we are using Postman/Newman as the Rest API tool to automate the ACI Configuration.
In this article I’m going to discuss on usin...
One of the first steps in building your ACI Fabric is to go through Fabric Discovery. While Fabric Discovery is usually a straightforward process, there are various issues that may prevent you from discovering an ACI switch. This article wil...