I'm trying to retrieve information about my rservers, associated ip-addresses and current state. I'm using the following syntax:
snmpwalk -c snmp4you@MED-TEST 10.10.5.36
MED-TEST is the user context and 10.10.5.36 is the ip of the admin-context, as I've understood, that all snmp-interaction has to be done via the Admin-context. I get tons of output back, but nothing about rservers and associated info.
I'm most likely doing something wrong, but I can't seem to find out what.
Why do you need native HA: The native HA feature allows two Cisco DCNM
appliances to run as active and standby applications, with their
embedded databases synchronized in real time. Therefore, when the active
DCNM is not functioning, the standby DCNM will...
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...