Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SSL module restart

Hi,

not very content networking specific but...

I'd like to reset SSL module in my 6509. When I try to set reload command in SSL I get this:

SSL_primary#reload at 3:00

Reload to the ROM monitor disallowed from a telnet line.

Set the configuration register boot bits to be non-zero.

and I have a register on SSL set to 0x0, but I can't find config-register command in SSL config mode. What would be the apropriate command to change register on module?

Is it possible to run "hw-module module 4 reset" to run and specific time?

tia

  • Application Networking
2 REPLIES
Silver

Re: SSL module restart

You will find the config-register command in the global config mode. You will find information on the usage of this command at http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124cr/hcf_r/cfn_02h.htm#wp1031618

New Member

Re: SSL module restart

I think this is not this, as in MSFC I have already config-register set to correct value but on SSL module it's still 0x0.

thx

214
Views
0
Helpful
2
Replies