I have 3 Windows 2008 Terminal Servers (for example: TS1, TS2 and TS3). On the ACE4710 I have a VIP address (DNS name = TSserver.mydomain.ch) which load balance the sessions between the servers and does source-IP sticky.
The problem I see is that the client PC opens a TS session to "TSserver.mydomain.ch". This session is for example sent to the server TS1. Then client PC refuse the Single Signon because the remote Terminal Server responds with "TS1.mydomain.ch" during the SSO.
At this point the user is prompted for "user name" and "password". If we log in normally the TS session is working fine.
But what we wanted is SSO !
I am not sur if we can do something on the ACE because I think this is a name problem between the PC, which connects to the VIP's DNS name and the real server responding with it's real host name!
The unmanaged mode is also known as Network only switching, which is introduced in Brazos release. It adds the flexibility for customer to use only network automation for service appliance.
If a device is configured a...
Usually, we can access ESXi Shell by pressing Alt+F1 from ESXi DCUI (Direct Console User Interface).
But on HyperFlex system, it just shows black window.
This is expected behavior because HyperFlex redirects ESXi Shell output to SoL...
Configuring an Export Policy Using the GUI
This procedure explains how to configure an Export policy using the APIC GUI. Follow these steps to trigger a backup of your data:
On the menu bar, choose Admi...