Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Standby Group conflict with the Virtual Blade NIC

I'm running oe574-4.1.3.55 on a WAE574, I've created Standby Group 1 but when I tried to map the virtual-blade to the NIC it failed with following error:

GigabitEthernet 1/0 is part of an Standby group. To use this interface in a virtual blade, it must be removed from

the Standby group.

Is it not possible to use "standby group" with the virtual-blade ?

1 REPLY
Silver

Re: Standby Group conflict with the Virtual Blade NIC

When you configure the virtual blade network interface card emulation in WAAS version 4.1.1c or 4.1.1d, you can select E1000 (an Intel E1000 NIC emulator) in addition to the rtl8139 and virtio emulators.

For more information on mapping the Virtual -blade to the NIC, please follow up on this link:

http://www.cisco.com/en/US/docs/app_ntwk_services/waas/waas/v411/release/notes/ws411rn.html#wp64158

116
Views
0
Helpful
1
Replies