Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Sticky issue when failed server become active

Hi,

We are operating the ace(csm) and using the sticky option.

Assuming that We have two servers with sicky for redundancy and being opreated active - active, 

I realized that if one server go down and go up, Csm dosen't forword packet to restored server.

I think it is due to the sticky option. We need csm to play loadbalancing two servers once one is restored immediately.

Is there anything opinion or solution?

Thanks,

1 REPLY
Bronze

Sticky issue when failed server become active

If a real goes down (fails probe) then the csm will remove it from service and not send connections to it. The entry will also be removed from the sticky table. When it comes back, it will receive new connections when it is elgible. If all incoming connections match existing sticky entries then it will take time to gather load. If you configure "predictor leastcons" under the serverfarm and limit the sticky life, then it will allow the failed real to recover load quicker. Matthew

281
Views
0
Helpful
1
Replies
CreatePlease login to create content