Hi all, I wondered whether anyone can shed light on this please. I have done some research and I don't think its possible but I thought I would ask.
I have a CSS that is providing Active/Standby for a server using a PrimarySorryServer. The server has multiple services running on it.
I am using scripts to check that the ports are alive which works well.
Should one of the ports fail any new requests are passed to the PrimarySorryServer. This also works well but the issue I have is that all ports need to be disconnected from the failed server and when they reconnect they will attach to the PrimarySorryServer.
This does not happen, existing ports are still attached to the old failed server. Is there any way to send resets for the VIP so that the clients are forced to reconnect ?
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...
Introduction This document will run you through a step by step
configuration example of Inter VRF route leaking in Cisco Application
Centric Infrastructure(ACI). This article describes the steps with
screen shots of example configuration and some verifica...