I was wondering if any one could help with the following, I have an ACE module running 2.2 software and would like to change the predictor to least connections and add sticky for this,
probe http http-default interval 10 passdetect interval 30 expect status 200 200 connection term forced
rserver host one ip address x.x.x.x inservice rserver host two ip address x.x.x.x inservice rserver host three ip address x.x.x.x inservice rserver host four ip address x.x.x.x inservice
serverfarm host serverfarm predictor hash address source probe vle-http-probe rserver one rserver two inservice rserver three inservice rserver four inservice
class-map match-all VL10-class 2 match virtual-address x.x.x.x any class-map match-all VL-class 2 match virtual-address x.x.x.x any class-map type management match-any remote_access 2 match protocol ssh source-address x.x.x.x 3 match protocol telnet source-address x.x.x.x 4 match protocol icmp any
policy-map type management first-match remote_mgmt_allow_policy class remote_access permit
policy-map type loadbalance first-match Virt_Policy class class-default serverfarm serverfarm
Topology & Design:
Two ACI fabrics
Stretching VLANs using OTV
Both fabrics are advertising BD subnets into same routing domain
Some BDs(or say VLANs) are stretched, but some are not.
Endpoints can move betwee...
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
Topology &Design:Traffic flow within same fabric:Endpoint moves to Fabric-2Bounce Entry Times OutTraffic Black-holedSummarySolutionAppendix:
In the Previous articles of ACI Automation, we are using Postman/Newman a...