Hello we are trying to resolve a connection issue with our load balancer. I am not very familiar with it, the 4710 was configured by a contractor who now is gone. I can see connections being accepted by the LB by doing the show serverfarm BLAH but I cannot see any specific IP info.
So there is a nat-pool configured to source the connections from the 4710 to the rservers. On the rservers I see connections coming in from these NAT addresses.
tcp 0 0 ::ffff:10.237.147.82:4642 ::ffff:10.237.147.231:1042 ESTABLISHED
This is netstat output on one of the rservers. So now what I want to see is what outside source IP has been NATed to 10.237.147.231 address.
Can someone help me with what command is used to show NAT entries on the 4710s?
Topology & Design:
Two ACI fabrics
Stretching VLANs using OTV
Both fabrics are advertising BD subnets into same routing domain
Some BDs(or say VLANs) are stretched, but some are not.
Endpoints can move betwee...
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
Topology &Design:Traffic flow within same fabric:Endpoint moves to Fabric-2Bounce Entry Times OutTraffic Black-holedSummarySolutionAppendix:
In the Previous articles of ACI Automation, we are using Postman/Newman a...