Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Trying to run CSS11503 08.10.0.02 one-armed DNAT+SNAT with UDP 921

Is there a way to perform DNAT + SNAT and portmap disable on the CIsco CSS 11503. I need to do a DNAT in a one-armed configuration and the to SNAT for UDP traffic with SRC Port 9211 and DST Port 9211. I don't need loadbalancing but only NAT. Is there a way to solve this issue with ACL. Any help will be appreciated...

Thanks

  • Application Networking
1 REPLY
Cisco Employee

Re: Trying to run CSS11503 08.10.0.02 one-armed DNAT+SNAT with U

if you want to do DNAT, you have to it a content rule.

The vip will be nated to the service address.

Then you need a group to nat the client ip.

Finally, you need to use the command 'portmap disable' under the group to avoid port mapping.

Gilles.

354
Views
0
Helpful
1
Replies
This widget could not be displayed.