Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Unable to get connectivity to ACE

i am trying to get ip connectivity to my ace-module from the 6509.

In the switch i enter;

svclc multiple-vlan-interfaces

svclc switch 1 module 3 vlan-group 1

svclc vlan-group 1 505

There is an ip-adress on vlan 505 in the 6509. In the admin context of the ACE-module there is a vlan 505 up and running. Why can i not ping between the modules?

The sh arp in the ace displays;

================================================================================

IP ADDRESS MAC-ADDRESS Interface Type Encap NextArp(s) Status

================================================================================

10.x.x.x 00.00.00.00.00.00 vlan505 GATEWAY - * 2 req dn

4 REPLIES
Silver

Re: Unable to get connectivity to ACE

Hi,

you need to allow this.

Add following class, policy map and ACL.

class-map type management match-any REMOTE_ACCESS-CM

description Match management traffic

2 match protocol telnet any

3 match protocol ssh any

4 match protocol https any

5 match protocol icmp any

policy-map type management first-match REMOTE_ACCESS-PM

class REMOTE_ACCESS-CM

permit

access-list all permit ip any any

int vlan 505

access-group input all

service-policy input mgmt

no shut

HTH,

Dario

Community Member

Re: Unable to get connectivity to ACE

it doesn't make any difference;

Still unable to ping..

Heres the config..

access-list all line 1 extended permit ip any any

class-map type management match-any REMOTE_ACCESS-CM

description Match management traffic

2 match protocol telnet any

3 match protocol ssh any

4 match protocol https any

5 match protocol icmp any

policy-map type management first-match REMOTE_ACCESS-PM

class REMOTE_ACCESS-CM

permit

interface vlan 505

ip address x.x.x.x

access-group input all

service-policy input REMOTE_ACCESS-PM

no shutdown

Silver

Re: Unable to get connectivity to ACE

Can you post the output for

show int vlan 505

sh arp

are you running ACE on a C6500 VSS pair?

Tnx,

Dario

Community Member

Re: Unable to get connectivity to ACE

I assume you ment from the ACE, here it is..

sh int vlan 505

vlan505 is up

Hardware type is VLAN

MAC address is 00:1f:ca:7b:7d:e3

Mode : routed

IP address is 10.x.x.x netmask is 255.255.255.0

FT status is non-redundant

Description:not set

MTU: 1500 bytes

Last cleared: never

Alias IP address not set

Peer IP address not set

Assigned from the Supervisor, up on Supervisor

82 unicast packets input, 2916134 bytes

42798 multicast, 4 broadcast

0 input errors, 0 unknown, 0 ignored, 0 unicast RPF drops

4 unicast packets output, 5696 bytes

0 multicast, 85 broadcast

0 output errors, 0 ignored

sh arp

Context Admin

================================================================================

IP ADDRESS MAC-ADDRESS Interface Type Encap NextArp(s) Status

================================================================================

10.x.x.2 00.00.00.00.00.00 vlan505 LEARNED - * 2 req dn

10.x.x.10 00.1f.ca.7b.7d.e3 vlan505 INTERFACE LOCAL _ up

================================================================================

Total arp entries 2

Yes, ACE is located in a 6500 VSS-pair.

/Andreas

224
Views
0
Helpful
4
Replies
CreatePlease to create content