Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VIP configuration and content rules

Hi,

I have the following problem, i'm trying to add u virtual router to my content switch.

circuit VLAN89

ip address 195.177.246.121 255.255.255.128

ip virtual-router 111

ip redundant-vip 111 195.177.246.57

when i try to do this i'm getting the error could not find content rule or group for specified VIP. I then first try to create a content rule with this vip.

content ecms.railaccess.be

vip address 195.177.246.57

redundant-index 173

balance leastconn

add service proatriu0po21a0

add service problock0po22a0

advanced-balance sticky-srcip

sticky-inact-timeout 30

protocol tcp

port 52994

url "//ecms.railaccess.be/*"

active

When i try to do this i get the error:

VIP address needs to be associated with a virtual router.

What am i doing wrong?

Kind regards,

Frederik De Muyter.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: VIP configuration and content rules

1. define content rule without ASR config( redundant-index command).

2. Enable VIP redundancy (Do the redundant-vip config under circuit)

3. configure the global service index for a redundant service (assign redundant index to rule)

2 REPLIES

Re: VIP configuration and content rules

1. define content rule without ASR config( redundant-index command).

2. Enable VIP redundancy (Do the redundant-vip config under circuit)

3. configure the global service index for a redundant service (assign redundant index to rule)

New Member

Re: VIP configuration and content rules

Ok tnx for the help, i just didn't activate the rule then configured redunant-vip, activate rule.

But know i now why it doesn't work. Tnx.

199
Views
0
Helpful
2
Replies