Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VIP redundancy across wan link

I have two CSS switches seperated across a WAN (T1 private line) link. Is it possible to configure the routers on either end to bridge the traffic, so that I can run VRRP and configure VIP redundancy? Has anyone done this before?

Basically I have a css in two data center with front end internet connectivity, and a back end link that goes into a 2620 on either end. I want to make these routers bridges so that I can run VIP redundancy. Is there a configuration example for this? I think it should work because I would have a layer two connection to both switches, but I would appreciate any advice.

1 REPLY
New Member

Re: VIP redundancy across wan link

Here's a good starting point for configuring redundancy on the CSS

http://www.cisco.com/warp/public/117/cdn_top_issues/cdn_ti_redun_css.html

160
Views
0
Helpful
1
Replies