Presumably, even though these servers are at two different sites they are logically positioned in such a way that they could be load balanced (if you wanted to). If that is the case, then you could use the backup command to acheive your goal.
backup 192.168.1.1 192.168.2.1
bind 10.1.1.1 192.168.1.1
route 192.168.2.0 255.255.255.0 wan-router
This configuration will cause all traffic to be directed to your main server and in the event that server is not available, then the backup server will be used, thus the WAN link will only be used during a failure scenario.
Topology & Design:
Two ACI fabrics
Stretching VLANs using OTV
Both fabrics are advertising BD subnets into same routing domain
Some BDs(or say VLANs) are stretched, but some are not.
Endpoints can move betwee...
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
Topology &Design:Traffic flow within same fabric:Endpoint moves to Fabric-2Bounce Entry Times OutTraffic Black-holedSummarySolutionAppendix:
In the Previous articles of ACI Automation, we are using Postman/Newman a...