Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

kmr
New Member

WAAS 4.1.1c - Optimized CIFS Sessions

I have 2 remote devices. Using the CM and looking at Dsshboard > Devices > Device1, then the Acceleration tab, I see "Insufficient data to plot the chart" for Optimized CIFS Sessions. I've got 25+ users at one location, and 3 users at the other. Shouldn't I see something about CIFS optimization? Something wrong with the report? Some other cli or something to verify the device is operating properly?

EDIT: both devices indicate insufficient information to plot the chart.

5 REPLIES
Silver

Re: WAAS 4.1.1c - Optimized CIFS Sessions

Try changing time period to last hour. Also make sure your cifs AO is running. Telnet to the WAEs and perform a 'show accelerator CIFS". Make sure it is running.

In addition if this is a new deployment users need to reconnect to CIFS servers in order to experience optimization. WAAS optimizes session based traffic upon receipt of a SYN

Cisco Employee

Re: WAAS 4.1.1c - Optimized CIFS Sessions

In addition to what Robert listed, use NTP on all your devices and validate that time is synchronized between WAEs and CM. If the time isn't synched, the reports won't show.

Dan

kmr
New Member

Re: WAAS 4.1.1c - Optimized CIFS Sessions

sho cifs accellerator:

Accelerator Licensed Config State Operational State

----------- -------- ------------ -----------------

cifs Yes Enabled Running

Changed report to "last hour", no change in report.

Verified NTP server is the same for all devices (perimeter data router). Time and timezone is accurate for all devices. Anything else I can check?

Cisco Employee

Re: WAAS 4.1.1c - Optimized CIFS Sessions

Are the other reports working ok? If you look at the overall traffic, does WAFS show up with traffic there as well?

Do you see entries in your connections that are using the CIFS AO? Try copying a couple of large files and validate it's using CIFS AO and then see if you get something in the graphes.

Thanks,

Dan

kmr
New Member

Re: WAAS 4.1.1c - Optimized CIFS Sessions

Whilst working on "other reports" I inadvertently added a second chart for Acceleration - CIFS - Optimized CIFS Session Count. This second chart does show information. I now have 2 of these charts. One indicates insufficient data, and the other chart shows 30-40 optimized CIFS sessions.

Go figure?

533
Views
0
Helpful
5
Replies
CreatePlease to create content