We are forwarding Symantec replication traffic via our WAAS infrastructure over a 20Mb WAN link. The CM appears to register the traffic but does not optimize it at all. Has anyone had any experience with WAAS and Symantec Veritas Volume Replicator (VVR) 4.3?
I tested with VVR in the lab. VVR default uses UDP and using the nerd knob in the GUI did not force VVR to start using TCP. To get VVR to use TCP, I had to input these commands:
vrport data 1999-1999
vrport heartbeat 2000-2000
or use what ever ports you want to use. The previous answer was asking if you were seeing TCP sessions in the WAE's. This can be seen by telneting to the WAE and issueing a "show tfo connection summary". Can you post the output of that command?
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
In the Previous articles of ACI Automation, we are using Postman/Newman as the Rest API tool to automate the ACI Configuration.
In this article I’m going to discuss on usin...
One of the first steps in building your ACI Fabric is to go through Fabric Discovery. While Fabric Discovery is usually a straightforward process, there are various issues that may prevent you from discovering an ACI switch. This article wil...