Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WAAS design to multiple sites

I'm currently running WAAS between our HQ office and a regional site via 2 P-To-P T1's with a 2851 router at each site. The HQ router also has a MPLS T1 that feed 3 other small regional offices. I want to convert the P-To-P T1's to a larger MPLS circuit that will handle all 4 sites from HQ.

My question is, if WAAS is currently running at HQ and only one of the 4 regional sites will it work or do I have to install WAAS network modules at the remaining 3 sites?

Thanks,

Rob

2 REPLIES

Re: WAAS design to multiple sites

If your goal is to have WAAS optimize the traffic for all sites, you will need a WAE device at each site.

If the goal is to only optimize the one regional site, this will work. The HQ WAE will see the traffic destine to your other sites and mark it as No Peer and put this traffic into path-through mode.

HTH,

Dan

New Member

Re: WAAS design to multiple sites

Great, thanks for the response. Yes, I only want to optimize traffic to the one site, the others are so small they barely use any bandwidth.

121
Views
0
Helpful
2
Replies