Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

WAAS - Error Message "Aggregation error" Showing up in SYSLOG

I am seeing the following message show up on my syslog for my WAAS device "tcpproxy: (111872) conn-id: 2021463: RE Aggregation error: process_full_tree failed -1105 (Read failed: not found) " This is not showing up on the logs on the WAAS itself. Is this "normal" stuff?

Thanks for your help.

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: WAAS - Error Message "Aggregation error" Showing up in SYSLO

This error means that the chunk was saved to some sig block but can not be read from it. It could be because something happened to the cache, for example sig blocks were

overwritten (FIFO). If the aggregation errors are few or occasional, these

errors should not impact performance.

Regards

Pete..

1 REPLY
Bronze

Re: WAAS - Error Message "Aggregation error" Showing up in SYSLO

This error means that the chunk was saved to some sig block but can not be read from it. It could be because something happened to the cache, for example sig blocks were

overwritten (FIFO). If the aggregation errors are few or occasional, these

errors should not impact performance.

Regards

Pete..

130
Views
0
Helpful
1
Replies
CreatePlease to create content