Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

WAAS : File preposition issue

Hi

I try to preposition some files on a WAVE-474-K9, running the 4.1.3a software version but without success.

In the syslog.txt file I have the following error message "java: %WAAS-CIFSAO-4-131237: (205218) Prepositon ID 1487942 failed, reason: network initialization error, retrying in 30 seconds" but on the WAE manager I have the following status :

In progress and it is running since 22 hours without any bytes copied.

Can someone help me to determine a possible root cause for this syslog error message.

Many thanks in advance.

Regards,
Sébastien.

1 REPLY
Cisco Employee

Re: WAAS : File preposition issue

Hi Sebastien,

Make sure traffic is being redirected to Data center WAE and that it has CIFS AO Enabled.

If you using WCCP redirect list then make sure you add Branch WAE IP address to the ACL.

You could also take tcpdump on Data center wae just before starting PP job to make sure traffic is being redirected to wae.

Run 'show accelerator' to make sure CIFS AO is Enabled.

Hope this helps,

Best Regards,
Rahul

627
Views
0
Helpful
1
Replies
CreatePlease to create content