Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

WAAS first setup

Hi, I have a new deployment I am working on.  I am unclear on the Inline setup. One location is configured as a trunk between the router and the switch, with voice and data traffic going through it. We will be installing a 294 inline at this site.

What impact will it have on voice traffic?  We are using G0/0 for management, not the Inline interfaces. Is that any additional configuraiton needed to inline if done this way? I didn't get prompted for vlan ID, or anything like that during the setup as an accelerator.

Are these setup with default optimizations out of the box, or is there additional programming needed once they are online?  I found where to build custom applications, but wonder if there is anything needed to be done once they are online for default traffic.

1 REPLY
Bronze

WAAS first setup

I dont know if you got this sorted, but you should post your question to the WAAS section under data centre (this section is primarily for load balancers). Matthew

366
Views
0
Helpful
1
Replies
CreatePlease to create content