Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

WAAS inline deployment options

Hi,

Can someone answer this basic question? I cant seem to find that much documentation on the inline modules.

Can you confirm whether or not devices can see each other on layer 2 across the two groups of an inline WAAS Ethernet module? i.e., if I have a router connected to the WAN of group 1 and another connected to the WAN of group 2, and the two routers are running HSRP (or even an ASA cluster), will they see each other correctly?

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: WAAS inline deployment options

"As if they were directly connected to the switches." That would be the correct way to look at it. Group 1 and group 2 are completely separate and there is no routing or bridging between them.

Dan

3 REPLIES
Cisco Employee

Re: WAAS inline deployment options

The devices cannot see each other across the inline groups, only the device on the other interface in the inline group.

Traffic does not cross between group 0 and 1, it has to use a networking device like a switch to see the other device in your example.

Hope that helps,

Dan

Community Member

Re: WAAS inline deployment options

Thanks for that. So if I had

Group1 = router1 - WAAS inline group1 - LAN switch

Group 2 = router2 - WAAS inline group2 - LAN switch

The routers would see each other through the WAAS and then the LAN switches (as if they were just connected to the switches), but wouldn't see each other directly across the WAAS module? Or you mean they don't see each other at all?

Cheers

Cisco Employee

Re: WAAS inline deployment options

"As if they were directly connected to the switches." That would be the correct way to look at it. Group 1 and group 2 are completely separate and there is no routing or bridging between them.

Dan

296
Views
5
Helpful
3
Replies
CreatePlease to create content