Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

WAAS - inlinegroup duplex

Hi,

my customer has some problems with performance on the WAN link. What is the Cisco recommendation for the following situation.Into the InlineGroup 1/0 is connected router into WAN port and switch into LAN port. The router has set full-duplex on the FastEthernet port(here is cross-over cable). Gigabit interface on switch is in the auto mode (here is straight cable). InlineGroup 1/0 is set to full duplex. Is it a correct setting? Or I have to set Gigabit interface on the switch to the full-duplex and speed 100? Thank you.

Roman

3 REPLIES
Cisco Employee

Re: WAAS - inlinegroup duplex

Roman,

The speed and duplex settings between the router, inline module, and switch all need to match.

Regards,

Zach

New Member

Re: WAAS - inlinegroup duplex

It meens: when I have configured the full-duplex on the router interface, I have to set the full-duplex in the inlinegroup 1/0 on WAE and full-duplex in the Gigabit interface on the switch, isn't it? It is same for speed, isn't it?

So the configuration will be following:

1/ router

int fas 0/0

duplex full speed 100

2/ wae

int inlinegroup 1/0

full-duplex

band 100

3/ switch

int Gi 1/0/1

full-duplex

speed 100

Cisco Employee

Re: WAAS - inlinegroup duplex

Yes. The speed and duplex need to match end-to-end.

Regards,

Zach

325
Views
0
Helpful
3
Replies
CreatePlease to create content