I'm seeing total output drops increment every now and then. We are using 3750E stack switch and are configured for WCCP L2 forward and return. Anyone know why I'm seeing out drops on the WAAS connected interface? The WAAS interfaces are setup as standby. The model is 7371...
description ****WAAS1 GIG 1/0****
switchport access vlan 738
mls qos trust dscp
GigabitEthernet1/0/4 is up, line protocol is up (connected)
Hardware is Gigabit Ethernet, address is 0022.be97.9804 (bia 0022.be97.9804)
Description: ****WAAS1 GIG 1/0****
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s, media type is 10/100/1000BaseTX
input flow-control is off, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:03, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 281
Topology & Design:
Two ACI fabrics
Stretching VLANs using OTV
Both fabrics are advertising BD subnets into same routing domain
Some BDs(or say VLANs) are stretched, but some are not.
Endpoints can move betwee...
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
Topology &Design:Traffic flow within same fabric:Endpoint moves to Fabric-2Bounce Entry Times OutTraffic Black-holedSummarySolutionAppendix:
In the Previous articles of ACI Automation, we are using Postman/Newman a...