WAAS Mobile server is installed on a Windows Server 2003 R2, which is a member of Domain. The problem we have is that Mobile Client fails UDP test on startup. This failure occurs both with the client connected across a VPN as well as on the same segment as the Server. The questions are:
1. Can a WAAS Mobile Server be installed on a Domain Member Server or does it require a standalone platform?
2. What would cause the client to fail UDP test and how can I troubleshoot it?
It is recommended not to run any other applications on the WAAS Mobile Server.
Also, if an antivirus software is running you will need to allow any outgoing ports the server may use. In addition check to make sure if a firewall is between the client and mobile server. if so, you will need to allow TCP / UDP port 1182.
I am attaching the configuration guide for your reference.
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...