Hello, I have recently deployed an 11 site WAAS solution with 512s at all the branches and a 612s at two "central" locations. I am running WAFS and have enabled prepositioning to push out user files to each location.
As I pushed the files, the "preposition status" indicated that the transfer had terminated with the message "Preposition size limit was exceeded."
Is there any way to see the presence of the prepositioned files on the WAE appliance so I can determine which files were successfully transferred?
There is currently no way to display the objects that are prepositioned. However, you can enable the EnhanceDebugging feature in Expert Mode, which will generate more verbose logging for PP -- including the names of the files that are pre-positioned. You can find the parameters on the WAE running the WAFS Edge service:
This document covers the important troubleshooting data to be collected and data collection procedures when you experience an issue with ACI fabric. The collection of the relevant troubleshooting data is very critical to root cause the issue and...
There are certain situations in where an On-Demand Techsupport is not able to be performed. In such cases, a local techsupport can be collected instead for either the APIC or an ACI switch. This document outlines this...
Webcast: Evolution of Data Center: From Classic Ethernet to VXLAN
(Live Webcast Tuesday May 15, 2018 at 10 am Pacific/ 1 pm Eastern / 7 pm Paris)
Register today for this live Cisco Support Community webcast.