What is the recommended method for configuring WCCP on the WAAS to register to an ISR router running version 12.4(24)T? I been going back and forth on whether or not to use L2 forward/return w/mask or GRE forward/return w/mask or hash. I have to do the egress method as "negotiated-return" because of the way we have 2 ISR routers setup.
Thanks for responding to my question. You can however perform L2 on an ISR router running 12.4(20T) or higher. I'm running 12.4(24T) and was wondering if L2 on an ISR will cause CPU to spike up... A huge benefit to go with L2 is you can see the original and optimized side traffic using TCPDUMP with a pre captured filter on the command line... I may leave it at GRE forward & return if the CPU would be an issue, may be can use this method with mask assign instead of the default hash; this way I can get better load balancing by going with mask assign, but then again I'm not sure if using mask assign will cause any issues.
The unmanaged mode is also known as Network only switching, which is introduced in Brazos release. It adds the flexibility for customer to use only network automation for service appliance.
If a device is configured a...
Usually, we can access ESXi Shell by pressing Alt+F1 from ESXi DCUI (Direct Console User Interface).
But on HyperFlex system, it just shows black window.
This is expected behavior because HyperFlex redirects ESXi Shell output to SoL...
Configuring an Export Policy Using the GUI
This procedure explains how to configure an Export policy using the APIC GUI. Follow these steps to trigger a backup of your data:
On the menu bar, choose Admi...